Above Ground Cube Tile Replacement Swimming Pool Overlap Liners 15ft Round

Above Ground Cube Tile Replacement Swimming Pool Overlap Liners 15ft Round

Above Ground Cube Tile Replacement Swimming Pool Overlap Liners 15ft Round
Above Ground Cube Tile Replacement Swimming Pool Overlap Liners - 15ft Round. Above Ground Replacement Liners are all plain blue overlapping liners which are stretched into place, this can be a difficult task to do so please follow the instructions below. Its is vital to check that all levels and measurements are correct before positioning. The cove is a vital structural element that prevents water pressure from forcing the liner out under the bottom rail. So please be sure that cove is installed correctly by manufactures guidelines. Check the pool floor (area inside the walls) for level ness. Fill in all depressions and remove any stones or sharp object from floor.

Place liner on the top of top rail, the liner should have overhanging the outside wall by 12 inches. Hold end and unroll liner down middle of pool as you would carpet, do not place liner seam over skimmer or return fitting openings. Work in both directions from the point where is already overhanging, unfold liner drape over the top rail and down the sides approximately 24 inches.

The liner should be barely above the pool floor in the centre only. Remember that the centre seam or centre of the liner should be inside the pool about 12 inches below the top rail. Correct any bunching or pleating conditions in the liner wall. Inspect the liner for open seams if any found return to dealer for prompt replacement of liner. With the liner in position, hold in place by attaching heavy duty clips over folded cardboard on the underside of each top rail. Carefully cover the end of the garden hose with a sock and tape securely, once this is done place hose inside the pool and start filling. As pool fills the liner will stretch as the water begins to cover the bottom. At this point check the walls for EXTREME tautness, release clips if need be but be sure not to release too much slack as this will cause creases. When releasing the clips you will also need to keep in mind the clips will need to be loosened evenly for whole circumference of the pool (advice very little amounts at a time).

Once the water reaches past the cove the tension should ease off dramatically and you should have a no wrinkles on floor. Creases in the wall can be removed by re-taunting the liner over the wall. With the help of two or three people, raise and hold liner up from any three top rail sections. Remove some of the top rail completely and stretch liner over metal wall as tight as possible, then re-erect the top rail with the liner in position and repeat the procedure all the way round the pool (Remembering only taking 2-3 sections off at one time) Once this is completed and the water is at correct level then the water can be turned off and cuts to the liner can be made. If all payments can be made when purchasing your products we will be able to ensure your item is dispatched straight away.

If you have any questions do not hesitate to send us a message or call for advice using our contact details on this page. The item "Above Ground Cube Tile Replacement Swimming Pool Overlap Liners 15ft Round" is in sale since Friday, August 21, 2015. This item is in the category "Garden & Patio\Swimming Pools & Hot Tubs\Pool Equipment & Parts\Pool Liners". The seller is "bayfronttrading" and is located in Sevenoaks. This item can be shipped to United Kingdom.
Above Ground Cube Tile Replacement Swimming Pool Overlap Liners 15ft Round